Tomographic series alignment without fiducials

Tomographic reconstructions without fiducial markers are always of lesser quality than with markers. However, it is valuable in many situations where the addition of markers to a specimen may be problematic. The tilt axis and tilt angles must be known to a good accuracy. Because the tilt axis is fixed for a specific microscope installation, it can be determined by doing a fiducial-based tilt series of any arbitrary specimen (such as gold particles on carbon).

The algorithm here attempts to do subset reconstructions to improve the signal-to-noise ratio for cross-correlation. It does this iteratively to improve the alignment.

As stated in the page on preparation, the .mdoc files produced from SerialEM can be used directly in Bsoft. Alternatively, all the parameters can be set up as on the preparation page. The fastest way of aligning the tilt series is one command line:

btomaln -verb 1 -align 3,1,3 -resol 20 -edge 20,3 -lambda 2165 -out 20190117_RS1_G6_10_aln.star 20190117_RS1_G6_10.mrc.mdoc

The -align option takes three parameters:

The -resolution option sets the high resolution limit for cross correlations

The edge option smooths the edges of the micrographs which includes erasing extraneous areas at high tilts. The parameters are the width of the edge and the standard deviation of the transition, both in pixels

The -lambda option specifies the proportionality parameter for estimating the thickness (see the section on thickness).

As with other operations, the alignment can be done from bshow. Select the "Workflow/Align micrographs" item to obtain the fllowing dialog window:

Alignment dialog

The output is written to a text window that can be saved using the "File" menu.

At this stage the results are not yet in bshow memory. Close the text window and click on the "Load" button in the "AlignMicrographs" window to load the new parameter file in memory.